Connecting A Terminal To The Server Blade - HP Integrity BL870c User's & Service Manual

Figure 30 Connecting the SUV Cable to the Server Blade

Connecting a Terminal to the Server Blade

Use the following procedure to establish a connection from your server to your terminal (or emulator
device).
CAUTION:
not intended to provide a permanent connection.
1. Connect the standard DB9f to DB9f modem eliminator cable to the RS-232 port on the SUV
cable.
2. Connect the other end of the DB9f to DB9f modem eliminator cable to your terminal device.
For more information about iLO 2 MP functions, see the HP Integrity iLO 2 Operations Guide.
3. Verify that the parameters for RS-232 serial port communication are set to the following values
on your terminal or emulator device:
VT 100 protocol
8/none (parity)
9600 baud
None (receive)
None (transmit)
4. Click OK to set the parameters.
5. If running an emulator, launch it now.
6. This ends the
7. Continue with
Disconnect the SUV cable from the port when not in use. The port and connector are
"Accessing the iLO 2 MP with No Network Connection"
"Configuring the iLO 2 MP" (page 48).
Accessing the Integrated Lights Out 2 Management Processor
procedure.
47