Removing A Processor - HP Integrity BL870c User's & Service Manual

Figure 50 Processor Slots on the System Board

Removing a Processor

Removing processor 1 is shown in this procedure.
If you are only installing a processor, remove the dust cover from the processor socket and proceed
to "Replacing a Processor" (page
These procedures apply to all processors on the system board.
To remove a processor:
1. Power off the server and remove it from the enclosure.
See "Preparing the Server Blade for Servicing" (page
2. Remove the access panel for the processor you are removing.
See "Removing the Access Panels" (page
3. Disconnect the power cable from the processor you are removing.
4. Loosen the captive screws (1 - 2) on the processor with the Torx T- 1 5 screwdriver. See
(page 126).
127).
29).
113).
Removing and Replacing a Processor 125
Figure 51