Maintenance; Inspection; Cleaning The Equipment - Precor M9.33 Owner's Manual

Maintenance

It is important to perform the minor maintenance tasks
described in this section. Failure to maintain the treadmill as
described here could void the Precor Limited Warranty.
To reduce the risk of electrical shock,
DANGER
always unplug the unit from its
power source before cleaning it or
performing any maintenance tasks.

Inspection

Inspect the treadmill daily.
1. Look and listen for slipping belts, loose fasteners, unusual
noises, worn or frayed power cords, and any other
indications that the equipment may be in need of service.
If you notice any of these, obtain service.
Important: If you determine that the treadmill needs
service, ensure that the treadmill cannot be used
inadvertently. Turn the unit OFF, and then unplug the
power cord from its power source. Make sure other users
know that the treadmill needs service.
Owner's Manual: Maintenance
2. Check for worn, frayed or missing security lanyards.
Replace missing or worn safety lanyards immediately.
Do not exercise on the treadmill without attaching the
security clip to your clothing.
To order parts or to contact a Precor authorized service
provider in your area, refer to Obtaining Service.

Cleaning the Equipment

Most of the working mechanisms are protected inside the
hood and base of the treadmill. However, for efficient
operation, the treadmill relies on low friction. To keep the
friction low, the unit's running belt, staging platforms, and
internal mechanisms must be as clean as possible.
Precor recommends the treadmill be cleaned before and
after each workout. Use mild soap and water to dampen a
soft cloth and wipe all exposed surfaces. This helps remove
any dust or dirt.
CAUTION: Do not use any acidic cleaners. Doing so will
void the Precor Limited Warranty. Never pour water or
spray liquids on any part of the treadmill. Allow the
treadmill to dry completely before using.
44