Assembly; Part Identification Chart - Weider Pro 8900 User Manual

ASSEMBLY
To make assembly easier, carefully read the
following information and instructions:
- Assembly requires two persons.
Because of its weight and size, assemble the
weight system in the location where it will be
used, Make sure that there is enough clearance
to walk around the weight system.
- Place all parts in a cleared area and remove the
packing materials, Do not dispose of the packing
materials until assembly is completed.
- For help identifying small parts, use the PART
IDENTIFICATION CHART on pages 5 and 6.
- The following tools (not included) may be required
for assembly:
two adjustable wrenches
one rubber mallet _
one standard screwdriver
one Phillips screwdriver _zb======_
Assembly may be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
,
Orient the Base (1) and the Side Stabilizers (2)
as shown.
Attach the Side Stabilizers (2) to the Base (1)
with two M10 x 95mm Bolts (78) and two M10
Locknuts (74), Do not fully tighten the
Locknuts yet.
74
78
Warning
Decal
78
2
,
Orient the U-stabilizer (3) and the Foot Plate (4)
as shown. Make sure that the textured side of
the Foot Plate is facing upward.
Attach the Foot Plate (4) to the U-stabilizer (3)
with two M8 x 65mm Button Screws (82). Do
not overtighten the Screws; the Foot Plate
must pivot easily.
82
7