Table of Contents
Advertisement
WARNING
Shock or fi re risk.
Use ONLY optional accessories approved for
this appliance.
• Using non-listed accessories voids warranty.
• Using non-listed accessories may result in a
safety hazard.
• Only Hearth & Home Technologies approved
accessories may be used safely.
D. Install the Refractory
Figure 12.4
STEP 1.
Place the back piece of refractory in back of the fi rebox.
The small indentation on one side goes down. Lean the
refractory slightly so it doesn't tip over.
Figure 12.5
STEP 2.
Place the left side refractory onto the left side of the burner.
Push the back refractory against the back wall. Place the
bumps on the bottom of the left refractory into the grooves
on the burner surface. Push to top gently against the side
of the fi replace. Once in place push it back so the bevel
cuts sit against each other and the seam is minimized.
STEP 3.
Repeat step 2 for the right side.
36
Heat & Glo • 6000GCF-IPI, 6000GCF-IPILP • 2110-900 Rev. G • 9/08
Figure 12.6
E. Ember Placement
WARNING
Explosion Risk.
• Follow ember placement instructions in manual.
• Do NOT place embers directly over burner ports.
• Replace ember material annually.
Improperly placed embers interferes with proper burner
operation.
Placing the Ember Material
Ember material is shipped with this gas appliance. To place
the ember material:
• Embers CANNOT be placed directly over ports. Care
should be taken not to cover the lighting trail of ports
(from back to front).
• When placing Glowing Embers
should be taken so that the ports are not covered. Place
the dime-size ember pieces just in front of the port trail,
but not on or in between the ports (see Figure 12.1).
Failure to follow this procedure will likely cause lighting
and sooting problems.
Figure 12.1 Placement of Embers
• Place Mystic Embers on areas of base refractory away
from port holes. Use this material to give the appliance
a realistic ash bed.
• Save the remaining ember materials for use during
appliance servicing. The embers provided should be
enough for 3 to 5 applications.
®
onto the burner care
EMBER MATERIAL
Advertisement
Table of Contents
