Appliance Setup; Fixed Glass Assembly; Clean The Appliance; Install Glass Refractory Panels - Heat & Glo MEZZO36 Installation Manual

11

Appliance Setup

A. Fixed Glass Assembly
WARNING! Risk of Asphyxiation! Handle fixed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
• DO NOT strike, slam or scratch glass.
• DO NOT operate fireplace with glass removed, cracked,
broken or scratched.
• Replace as a complete assembly.
Removing Fixed Glass Assembly
1. Remove the decorative front from fireplace and set
aside on work surface.
2. Locate the glass latches that are on the upper edge of
the glass frame of the appliance. See Figure 11.1.
3. Use both index fingers to release the glass clips.
4. Allow glass to tilt forward. Grasp glass on the upper
return lip of glass frame and lift up and out. The glass
should lift easily out of the bottom retaining lip.
Replacing Fixed Glass Assembly
1. Locate retaining lip on lower front face of firebox.
2. Place glass assembly into retaining lip end. Tilt top of
glass assembly toward fireplace.
3. Assure proper left to right placement of glass and en-
gage all four spring latches.
GLASS CLIPS
BOTTOM RETAINING LIP
Figure 11.1 Fixed Glass Assembly
Heat & Glo • MEZZO36/ST, MEZZO48/ST MEZZO60/ST, MEZZO72/ST Installation Manual • 2300-970 Rev. L • 5/15
58
B. Remove the Shipping Materials/Install
Vanity Panel
Remove shipping materials from inside or underneath
the firebox. Verify all components are with the fireplace.
Unwrap the vanity panel and replace in the same location
as shown in Figure 11.2.
Figure 11.2 Vanity Panel Location
C. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the firebox or underneath in the control cavity.
D. Install Glass Refractory Panels
See-Through Models: Start at Step 3.
1. Single-Sided Models:
Set back glass panel, labeled A in Figure 11.3, into
firebox. Back panel will be held in place by the side
panels and will sit on the heads of the screws holding
the media tray in place. Set back glass panel against
the back wall of the firebox with the smooth side of the
glass facing outward. Insert retaining bracket through
the slot in the inner firebox heat shield. Line up the
existing hole in the heat shield with the hole closest
to the bend in the bracket and secure in place with a
screw.
Set left side glass panel, labeled B in Figure 1, into
firebox with the smooth side facing outward. Insert a
retaining bracket through the slot in the inner firebox
heat shield. Line up the existing hole in the heat shield
with the hole closest to the bend in the bracket and
secure in place with a screw. Ensure the side glass re-
fractory panel is stationary. See Figure 11.4. Repeat
for right side panel.
