Table of Contents
Advertisement
F. Positioning the Logs
If the gas logs have been factory installed they should not
need to be positioned. If the logs have been packaged
separately, refer to the following instructions.
STEP 1.
CAUTION: Logs are fragile! Carefully remove the
logs, grate and supporting cardboard from the
inside of the fi replace See Figure 12.8.
STEP 2.
Place the metal grate on top of the burner.
Position the legs of the grate into the forward set of
indentations in the burner top. Make sure the grate
is all the way forward. See Figure 12.9.
STEP 3.
Log #1 (SRV2103-107):
Place the log on the burner so the cutout in the
log goes around the hump in the burner. The outer
legs of the log should self center on the sides of
the burner. The ramp shape in the bottom of the
log sits fully against the ramp shape molded into
the burner. Pull the log forward. The right side of
log will touch the smaller hump. There will be a
1/4 inch or so gap around the hump. See Figures
12.10 and 12.11.
Figure 12.10 Front View
1 1
Heat & Glo • 6000GCF-IPI, 6000GCF-IPILP • 2110-900 Rev. G • 9/08
Log Assembly: LOGS-6000G
3 3
2 2
Figure 12.8
HUMP
HUMP
Figure 12.9
Figure 12.11 Top View
1 1
4 4
5 5
SMALLER
SMALLER
HUMP
HUMP
INDENTATIONS
INDENTATIONS
1 1
2103-910
37
Advertisement
Table of Contents
