Install Glass Refractory (True-36G-Ift/True-42G-Ift Only) - Heat & Glo TRUE-36G-IFT Installation Manual

D. Install Glass Refractory (TRUE-36G-IFT/
TRUE-42G-IFT Only)
CAUTION! Risk of Cuts or Abrasions. Wear protective
gloves and safety glasses during installation.
NOTICE: Handle refractory panels with care. Refractory
may chip or crack if dropped or impacted.
TOOLS
Screw gun equipped with 1/4 in. socket or
1/4 IN. wrench or socket
Utility Knife
Flat Screwdriver
REFRACTORY COMPONENTS
(1) Black Glass Left Panel
(1) Black Glass Right Panel
(1) Black Glass Rear Panel
(2) Finish Trim Pieces
(1) Top Refractory Panel
INSTALLATION
1. Remove glass from the front of the appliance. Re-
move all shipping materials from inside the 昀椀rebox.
See Figure 11.9.
REMOVE ALL SHIPPING MATERIALS REMOVE ALL SHIPPING MATERIALS
RETAINING TABS RETAINING TABS
Figure 11.9 Remove Shipping Materials
Heat & Glo • TRUE-36-IFT, TRUE-42-IFT, TRUE-50-IFT Installation Manual • 2461-980 Rev. Y • 6/23
2. Carefully remove top refractory by straightening the
retaining tabs. Set refractory panel aside for later
use. See Figure 11.9.
3. Separate the shipping bracket from the log grate by
cutting the zip tie with a utility knife. See Figure 11.10
SHIPPING BRACKET SHIPPING BRACKET
CUT ZIP TIE CUT ZIP TIE
MOVE REFRACTORY MOVE REFRACTORY
FORWARD OR REMOVE FORWARD OR REMOVE
Figure 11.10 Separate Shipping Bracket from Log Grate
4. Bend shipping bracket up slightly, exposing the two
screws that retain the shipping bracket to the log
grate. Remove the screws and discard shipping
bracket. See Figure 11.11.
REMOVE SCREWS REMOVE SCREWS
Figure 11.11 Remove Shipping Bracket
5. Slide the two left base refractory pieces and one right
base refractory piece forward or remove completely.
See Figure 11.10.
6. Using a 昀氀at screwdriver, straighten hand bends on the
refractory tabs at the top of the side spacers (left and
right) to allow the side spacers to be moved forward
about three inches. See Figure 11.12.
55