Table of Contents
Advertisement
E.
Junction Box Installation
If the box is being wired from the OUTSIDE of the
appliance:
• Install the
Romex™
connector (not included
with appliance) in the side wrap.
• Loosen two screws on the Romex connector,
feed the necessary length of wire through the
connector and tighten the screws.
• Make all necessary wire connections.
If the box is being wired from the INSIDE of the
appliance:
• Remove the screw attaching the junction box
to the outer shell, rotate the junction box
inward to disengage it from the outer shell
(see Figure 7.4).
• Pull the electrical wires from outside the
appliance through this opening into the valve
compartment.
F.
Wall Switch Installation for Fan (Optional)
If the box is being wired to a wall
mounted switch for use with a fan
(See Figure 7.5):
• The power supply for the
appliance must be brought into
a switch box.
• The power can then be supplied
from the switch box to the
appliance using a minimum of
14-3 with ground wire.
• At the switch box connect the
black (hot) wire and red (switch
leg) wire to the wall switch as
shown.
• At the appliance connect the
black (hot), white (neutral) and
green (ground) wires to the junc-
tion box as shown.
• Add a 1/4 inch insulated female
connector to the red (switch leg)
wire, route it through the knock-
out in the face of the junction
box, and connect to the top fan
switch connector (1/4 inch
male) as shown.
• Loosen the two screws on the Romex connector, feed the
• Make all necessary wire connections to the receptacle and
FAN
SPEED CONTROL
(RHEOSTAT)
Figure 7.5 Junction Box Wired to Wall Switch
Heat & Glo LifeStyle Collection • Twilight-II • 2087-900 Rev. G • 12/05
HEAT SHIELD
BLK
WHT
BLK
WHT
Figure 7.4
Junction Box Detail
necessary length of wire through the connector and tighten the
screws.
assemble the receptacle and cover to the junction box.
6 INCH
APPROX.
FAN
PLUG AND WIRE
ASSEMBLY
14/2WG
COPPER GROUND
ATTACHED TO GRN SCREW
WITH GRN WIRE
GREEN WIRE
INSIDE BOX
NOTE: Do NOT wire
110VAC to wall switch.
WIRE LEAD
1 MALE END
1 FEMALE END
TEMPERATURE
SENSOR SWITCH
WIRE LEAD
2 FEMALE ENDS
JUNCTION
BOX
6 INCH
APPROX.
OPTIONAL
WALL SWITCH
17
Advertisement
Table of Contents
