Optional Accessories - Heat & Glo LifeStyle Twilight-II Owner's Manual

Installation and operation
Table of Contents

Advertisement

C. Optional Accessories
Optional fan and remote control kits require that 110-120
VAC be wired to the factory installed junction box before
the appliance is permanently installed (see Figure 7.1).
Fan Installation
To provide best airflow, we recommend positioning fan on
the left side (as viewed from appliance interior side - see
Figure 7.2). NOTE: It is recommended fan be installed
prior to gas line installation.
Wall Switch
Position the wall switch in the desired position on a wall.
Run a maximum of 25 feet (7.8 m) or less length of 18
A.W.G. minimum wire and connect it to the appliance ON/
OFF switch pigtails.
FAN SPEED
CONTROL
(RHEOSTAT)
PLUG AND WIRE
ASSEMBLY
Figure 7.1
Fan Wiring Diagram
WIRE LEAD
6 FT.
1 MALE END
1 FEMALE END
APPROX.
TEMPERATURE
SENSOR SWITCH
WIRE LEAD
2 FEMALE ENDS
6 FT.
APPROX.
FAN KIT
#GFK-160T
Heat & Glo LifeStyle Collection • Twilight-II • 2087-900 Rev. G • 12/05
APPLIANCE
INTERIOR
SIDE
FAN
DRIP
TRAY
Figure 7.2
Fan location
DETAIL A
JUNCTION BOX
SEE DETAIL A
NOTE: If any of the original wire as supplied with
the appliance must be replaced, it must be
replaced with the type 105
o
C rated wire.
15

Advertisement

Table of Contents
loading

Table of Contents