Table of Contents
Advertisement
E. Positioning the Logs
Log Set Assembly: LOGS-TWI
3
5
2
7
CAUTION: Logs are fragile! Carefully remove the
logs from the packaging. Remove the metal supports
which held the log box in place during shipping.
Indents
STEP 2.
LOG #1 (SRV2005-701): Use the indents on the bottom side of the log to position the large end of the
log onto the grate tine as shown. Position the thin end of log #1 one inch from port pattern as shown.
Grate Bar Cutout
STEP 3.
LOG #2 (SRV2005-700): Position log #2 on the left grate bar and the pilot assembly. Use the cut out
notches on the log to position it as shown.
22
1
4
6
Pilot
Assembly
Cutout
Heat & Glo LifeStyle Collection • Twilight-II • 2087-900 Rev. G • 12/05
STEP 1.
Before positioning the logs, refer to the
installation manual for electric ember set-up and ember
placement.
1-inch
2
1
1
2005-937D
Advertisement
Table of Contents
