Design And Installation Considerations; Tools And Supplies Needed; Inspect Heater And Components - Heat & Glo LifeStyle CF550E-B Owner's Manual

B. Design and Installation Considerations
CAUTION
Check building codes prior to installation.
• Installation MUST comply with local, regional,
state and national codes and regulations.
• Consult insurance carrier, local building inspector,
fi re offi cials or authorities having jurisdiction about
restrictions, installation inspection, and permits.
When planning a heater installation, it is necessary to deter-
mine the following information before installing:
• Where the heater is to be installed. See Sections
3 and 4.
• Electrical wiring. See Section 4.
• Framing and fi nishing details. See Sections 3 and 6.
• Whether optional accessories—devices such as a fan, wall
switch or remote control —are desired. See Section 11.
C. Tools and Supplies Needed
Before beginning the installation be sure the following tools
and building supplies are available:
Reciprocating saw
Pliers
Hammer
Phillips screwdriver
Flat blade screwdriver
Plumb line
Level
Surround
1/2-3/4 in. length, #6 or #8 self-drilling screws
Misc. screws and nails
CAUTION
• Keep heater dry.
• Mold or rust may cause odors.
Note: Minimum and maximum clearances must be
maintained at all times. Illustrations throughout these
instructions refl ect typical installations and are for design
purposes only. Actual installation may vary slightly due to
individual design preferences.
The illustrations and diagrams used throughout these
installation instructions are not drawn to scale.
6 Heat & Glo • CRESTFIRE Series Electric Fireplace • 4030-781 Rev F • 10/06
Framing material
Wall-fi nishing materials
Gloves
Framing square
Electric drill and bits
Safety glasses
Tape measure
D. Inspect Heater and Components
CAUTION
Sharp Edges
• Wear protective gloves
and safety glasses during
installation.
WARNING
Fire Risk
Inspect heater and components for damage.
Damaged parts may impair safe operation.
• Do NOT install damaged components.
• Do NOT install incomplete components.
• Do NOT install substitute components
Report damaged parts to dealer.
• Carefully remove the heater and components from the
packaging.
• Report to your dealer any parts damaged in shipment.
• Read all the instructions before starting the installation.
Follow these instructions carefully during the
installation to ensure maximum safety and benefi t.
Note:
• Illustrations and photos refl ect typical installations
and are FOR DESIGN PURPOSES ONLY.
• Illustrations/diagrams are not drawn to scale.
• Actual installation/appearance may vary due to
individual design preference.
• Hearth & Home Technologies reserves the right to
alter its products.