Trouble Shooting Chart - Murray 1695539 Operator's Manual

TROUBLE SHOOTING CHART
TROUBLE CAUSE CORRECTION
Difficult starting Defective spark plug. Replace spark plug.
Water or dirt in fuel system.
Engine runs erratic Blocked fuel line, empty gas tank, or stale
gasoline.
Engine stalls Unit running on CHOKE.
Engine runs erratic; Water or dirt in fuel system.
Loss of power
Excessive vibration Loose parts: damaged impeller.
Unit fails to propel itself
Unit fails to discharge snow
Drive belt loose or damaged.
Incorrect adjustment of traction drive cable.
Worn or damaged friction wheel.
Auger drive belt loose or damaged.
Auger control cable not adjusted correctly.
Shear bolt broken.
Discharge chute clogged.
Foreign object lodged in auger.
Use carburetor bowl drain to flush and refill with
fresh fuel.
Clean fuel line; check fuel supply; add fresh
gasoline.
Set choke lever to RUN position.
Use carburetor bowl drain to flush and refill with
fresh fuel.
Stop engine immediately and disconnect spark
plug wire. Tighten all bolts and make all
necessary repairs. If vibration continues, have
the unit serviced by a competent repairman.
Replace drive belt.
Adjust traction drive cable.
Replace friction wheel.
Adjust auger drive belt; replace if damaged.
Adjust auger control cable.
Replace shear bolt.
Stop engine immediately and disconnect spark
plug wire. Clean discharge chute and inside of
auger housing.
Stop engine immediately and disconnect spark
plug wire. Remove object from auger.
1742237 15