Setup Menu; Yuv/Rgb-In Select; Power Save; Pc Power Management - Panasonic TH-152UX1 Operating Instructions Manual

Setup menu

1
2
3
YUV / RGB-in select
This menu is displayed when DVI-D Terminal Board (TY-FB11DD) is installed to the unit.
YUV RGB
Select to match the signals from the source connected to the DVI input terminals.
YUV signals "YUV"
RGB signals "RGB"

Power save

Off On
When this function is turned On, luminous level of the Plasma Display is suppressed, so power consumption is
reduced.

PC Power management

Off On
When this function is set to On, it operates under the following conditions to turn the power on or off automatically.
When no pictures (HD/VD sync signals) are detected for 30 or so seconds during PC signal input:
Power is turned off (standby); the power indicator lights up orange.
When pictures (HD/VD sync signals) are subsequently detected:
Power is turned on; the power indicator lights up green.
Notes:
• This function operates only during PC signal input.
• This function is effective when "Sync" is set to "Auto". (see page 36)

Auto power off

Off On
Equipment power supply is turned Off when there is no signal.
When this is set to On, the power supply of the unit goes Off 10 minutes after the input signals stop.
34
Press to display the Setup menu.
Press to select the menu to adjust.
Press to adjust the menu.
Press to exit from menu.
Setup
3D Settings
Signal
Screensaver
Extended life settings
Input label

YUV/RGB-in select

RGB
Power save Off
PC Power management
Off
Auto power off
Off
English ( UK )
OSD Language