Pc Input Terminals Connection - Panasonic TH-152UX1 Operating Instructions Manual

PC Input Terminals connection

COMPUTER
Notes:
• With regard to the typical PC input signals that are described in the applicable input signals list (see page 47), adjustment
values such as for the standard picture positions and sizes have already been stored in this unit. You can add up to eight
PC input signal types that are not included in the list.
• Computer signals which can be input are those with a horizontal scanning frequency of 15 to 110 kHz and vertical scanning
frequency of 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200 lines.)
• If the number of pixels of input signal exceeds the following maximums, it may not be possible to show the ¿ ne
detail with suf¿ cient clarity. (SXGA compatible)
For vertical: 1,080 dots
For horizontal: 1,440 dots when the aspect mode is set to "4:3"
1,920 dots when the aspect mode is set to "16:9"
• The PC input terminals are DDC2B-compatible. If the computer being connected is not DDC2B-compatible, you will
need to make setting changes to the computer at the time of connection.
• Some PC models cannot be connected to the set.
• There is no need to use an adapter for computers with DOS/V compatible Mini D-sub 15P terminal.
• The computer shown in the illustration is for example purposes only.
• Additional equipment and cables shown are not supplied with this set.
• Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the speci¿ ed
frequency range.
• To use sync input VBS signals, use the connector which incorporates a 75-ohm termination resistance and which is
available on the market, for the connection of the HD connector where the VBS signals are to be input.
Signal Names for Mini D-sub 15P Connector
5 4 3 2 1
10 9 8 7 6
15 14 13 12 11
Pin Layout for PC Input
Terminal
Conversion adapter
(if necessary)
Pin No. Signal Name
1 R
2 G
3 B
NC (not connected)
4
GND (Ground)
5
Mini D-sub 15p
RGB
PC cable
(Male)
Pin No. Signal Name
6 GND (Ground)
7 GND (Ground)
8 GND (Ground)
+5 V DC
9
GND (Ground)
10
Connections
(Female)
Pin No. Signal Name
11 NC (not connected)
12 SDA
13 HD/SYNC
VD
14
SCL
15
11