SATO /gt Series Programmer's Reference Manual page 167

Unit 6: Bi-Directional Communications
DESIGNATION OF SWITCHING STATUS 5 RETURN (ESC + PL)
This command switching the communication protocol. Avoid the inclusion and use of this
command in the print data (<ESC>A - <ESC>Z). The specified contents are still in effect after the
printer is powered off.
This command is not available for the protocol that is not supported by the current interface. If
using LAN interface or changing from driver protocol (or vice versa), repower on the printer.
Normal transmission and reception of data cannot be performed without repowering.
PARAMETER (ESC + PL + a
a Switchover Designation -
DESIGNATION OF STATUS 5 RETURN CHECK (ESC + CR)
This command provides setup of the BCC Check function of Status 5 Return and the item
number. Avoid the inclusion and use of this command in the print data (<ESC>A - <ESC>Z).
PARAMETER (ESC + PL + a
a BCC Check -
b Item Number Check -
SATO E+ Programming Reference
0: Ready/Busy
1: Xon/Xoff
2: Status 2 Return
3: Status 3 Return
4: Driver Protocol
5: Status 5 Return
0: Not Available
1: Available
0: Not Available
1: Available
PN 9001149A Page 6-7