SATO /gt Series Programmer's Reference Manual page 116

Unit 4: Standard Command Codes
PRINT LENGTH, EXPANSION
FUNCTION To increase the maximum print length (in feed direction) for a label.
FORMAT
<ESC>EX0
<ESC>AR
Must follow the Start Code command within it is own separate data stream.
EXAMPLE
<ESC>A
<ESC>EX0
<ESC>Z
<ESC>A
<ESC>H0050<ESC>V0100<ESC>WB1EXPAND TO:
<ESC>H0050<ESC>V2700<ESC>WB1MAX INCHES
<ESC>Q1
<ESC>Z
<ESC>A
<ESC>AR
<ESC>Z
OUTPUT
(4-43)
NOTES
"EX0" is effective until "AR" is sent to reset the printer to its standard print length, or
until the printer is re-powered.
When this command is used with the Store Form Overlay (<ESC>&) command the
form length cannot exceed the maximum specified.
If a job contains elements out of the memory range, it is ignored.
If the Forms Overlay (<ESC>&) command is used with Expanded Memory to expand
the print area, the Form Overlay length is still limited to the maximum.
SATO E+ Programming Reference
Sets the print length to maximum
Resets the maximum print length to 7" (178 mm)
PN 9001149A Page 4-74