Internal Buffer, Recall - SATO /gt Series Programmer's Reference Manual

Unit 4: Standard Command Codes

INTERNAL BUFFER, RECALL

FUNCTION Obtains the stored data in the internal buffer and uses it as print data such as
character string or a barcode.
FORMAT
<ESC>IB
Place anywhere between <ESC>A and <ESC>Z.
EXAMPLE <ESC>A
<ESC>V100<ESC>H100<ESC>IB1, 2, 3,<ESC>BD304120<ESC>IB6
<ESC>Q1
<ESC>z
OUTPUT
(4-47)
NOTES Specify this command prior to the command that is subject to data replacement. Use
commas to data couple. Powering off the printer clears the stored data.
This command is available only when the data or parameter of command that is
subject to data replacement is not specified. When the parameter is specified for the
command of data replacement, data will not be replaced with <ESC>IB.
Internal buffer data can be obtained up to 1024 bytes at a time.
Within command, consecutive specification of identical internal buffer numbers is
available.
When specifying QR Code, parameter replacement in the mixed designation of
manual mode will be restricted to the cases listed below:
Refer to Appendix: Reference Table 32 for additional information.
SATO E+ Programming Reference
a = Internal buffer number (1 to 16)
1) Mixed Number = 1: Replacing normally.
2) Mixed Number = 1: Print data obtained by the command of Internal Buffer
Call (<ESC>IB) that was specified prior to the designation of QR Code print
will be consecuently replaced according to the value of mixed number.
3) When replacing the print data with <ESC>IB, the use of automatic mode is
recommended.
PN 9001149A Page 4-81