Operations Commands - Runco Quantum Color Q-650i Series Installation & Operation Manual

Serial Communications

Operations Commands

Table 6-1. Serial Command Key Names and IR Codes (continued)
RS232
IR Code
Keyname
0x10 (none)
0x13 (none)
(none) (none)
Operations commands allow more flexible and direct control of the projector. The syntax
for operations commands is as follows:
op <operation> <command>[CR]
(Precede <operation> and <command> with a space.)
The command type can be one of 5 functions:
Function Command
Set
= <value>
Get
Increment
Decrement
Execute
Table 6-2 lists the valid operations commands. For all but Execute functions, the response
from the projector is the command and "= <value>" where <value> is the current value or
"NA" if the value is not available. For Execute functions the response is the same
command. All responses are in UPPERCASE.
Some operations command examples:
Input: op bright ? [CR]
Response: OP BRIGHT = 100 [CR]
Input: op bright + [CR]
Response: OP BRIGHT = 101 [CR]
Input: op bright = 127 [CR]
Response: OP BRIGHT = 127 [CR]
Input: op bright - [CR]
Response: OP BRIGHT = 126 [CR]
Input: op resync [CR]
Response: OP RESYNC [CR]
Remote Button
The projector does not respond to this key.
ZOOM
The projector does not respond to this key.
LENS
Activates remote backlighting when pressed.
LIGHT
Operations Control Commands
Assigns that value to the parameter.
Returns the current value of that parameter.
?
Adds 1 to the current value.
+
Subtracts 1 from the current value.
-
Performs an action such as a reset.
(none)
76
Description
Description
Q-650i Series Installation/Operation Manual