To Create An Iscsi Target - Freecom SILVER STORE 2-DRIVE NAS User Manual

EN

To create an iSCSI target:

NOTE: Before you start to create an iSCSI target, make sure you have enabled
the iSCSI service. See "To configure the iSCSI service" for detailed instructions.
1. Click the iSCSI tab.
2. Click the iSCSI Target subtab.
3. Click the Add icon located on the lower left corner of the Storage page.
4. In the IQN (iSCSI Qualified Name) box, enter a name for the iSCSI target. This will be
name that appears in the Microsoft iSCSI initiator.
5. Click the optional Enable Header and/or Data Digest option to verify the iSCSI initiator
when it attempts to connect to the target .
6. Enable the One-way and Mutual CHAP feature to use CHAP (Challenge Handshake
Authentication Protocol) to authenticate connection between the iSCSI initiator and
the iSCSI target. When enabled, only the iSCSI target authenticates the initiator. Enable
this feature only if you want the client to perform an additional check to ensure that it
is accessing the correct target.
7. If One-way and Mutual CHAP is enabled, you must enter a CHAP user name and password.
8. Click Next.
9. Review your settings and then click Back to make any changes or click Submit to complete
iSCSI setup.
NOTE: Not only Windows computers can use iSCSI, there are more OS systems.
Also for instance: VMWARE appliances.
FREECOM SILVER STORE 2-DRIVE NAS
45