Extreme Networks ExtremeWare Enterprise Manager Installation And User Manual page 84

U I M
SING THE NVENTORY ANAGER
Note: These devices are NOT automatically entered into the Enterprise Manager
database. You must explicitly select and add devices to the database.
10 To add devices to the ExtremeWare Enterprise Manager database, select individual
devices or a range of devices in the Results list, and click the Add button at the
bottom of the window.
Note: If you select multiple devices, make sure the devices you select are similarly
configured. As part of the Add process, you will be asked for a single
password that will apply to all the selected devices. If the password is
specified incorrectly for any of these devices, the add will fail for those
devices.
11 A window (Figure 5-7) pops up where you must set additional device options such
as a write community string, the device group to which the devices should be
added, and a default device login and password. If there are Cisco devices among
the set being added, you must also enter a Cisco enable password.
Enter or make changes to any of these fields. These options will apply to the entire
set of devices you are adding.
Note: Make sure the device passwords are correct for the selected devices. If you
are adding multiple devices in one operation, make sure the passwords you
specify are correct for all those devices. A device cannot be added if the
password is not correct.
Figure 5-7: Setting default device options for discovered devices
12 Click OK to proceed with the Add process.
A message window (shown in Figure 5-8) pops up to show you the progress of the
Add command.
5-12 E W E M
XTREME ARE NTERPRISE ANAGER
I U G
NSTALLATION AND SER UIDE