Extreme Networks Device Requirements; Third-Party Device Requirements - Extreme Networks ExtremeWare Enterprise Manager Installation And User Manual

E W E M O
XTREME ARE NTERPRISE ANAGER VERVIEW
takes place, the ExtremeWare software in the switch uses the SmartTraps rules to
determine if the Enterprise Manager should be notified. These changes can be changes
in device status, such as fan failure or overheating, or configuration changes made on
the switch through the ExtremeWare CLI or ExtremeWare Vista.
The ExtremeWare Enterprise Manager does a "heartbeat" check, by default every five
minutes, of all the switches it is managing to determine if the devices are still accessible.
The ExtremeWare Enterprise Manager also provides you with the ability to explicitly
gather device status at any time using the Sync feature in the Inventory Manager
applet.
H S R
ARDWARE AND OFTWARE EQUIREMENTS
The following sections specify the hardware and software you need to run the
ExtremeWare Enterprise Manager software.
E N D R
XTREME ETWORKS EVICE EQUIREMENTS
The ExtremeWare Enterprise Manager can manage Extreme Networks Summit and
BlackDiamond switches running the ExtremeWare software release 2.0 or later within
the switch. However, features such as the Policy-Based Management Service require
ExtremeWare 5.0 or later.
T -P D R
HIRD ARTY EVICE EQUIREMENTS
ExtremeWare Enterprise Manager version 2.0 supports Cisco and Xedia devices as well
as Extreme Networks switches.
Cisco devices require IOS 11.2 or later. Cisco 2500, 3600, 4000 and 7505 devices have
been tested ExtremeWare Enterprise Manager Release 2.0.
Xedia devices require Xedia software 2.1. The Xedia Access Point switch has been tested
with ExtremeWare Enterprise Manager 2.0.
See the ExtremeWare Enterprise Manager Release Notes for the most current list of
qualified third-party devices.
1-8 E W E M I U G
XTREME ARE NTERPRISE ANAGER NSTALLATION AND SER UIDE