Extreme Networks e” series Hardware Installation Manual page 375

NOTE
Disconnect the fiber-optic cable from a mini-GBIC before removing the mini-GBIC from the switch.
To remove a mini-GBIC similar to Module A in Figure 181, press and hold the black plastic tab at the
bottom of the connector to release the mini-GBIC, and pull the mini-GBIC out of the SFP receptacle.
To remove a mini-GBIC similar to Module B in Figure 181, rotate the front handle and pull the
mini-GBIC out of the SFP receptacle.
NOTE
When removing a mini-GBIC (SFP) from a Summit 400 series switch, be sure to disconnect the fiber
cable to the mini-GBIC or link before you remove the mini-GBIC itself. It is important to follow this
disconnection and removal order. If you do not, the mini-GBIC LED may remain lit even though the
mini-GBIC is no longer present. To recover from this LED error mode if the mini-GBIC was incorrectly
removed, reinsert the mini-GBIC into the port, disconnect the fiber cable, and remove the mini-GBIC.
Extreme Networks Consolidated "e" and "i" Series Hardware Installation Guide
Installing Mini-GBICs
375