Diagnostics Mode Selections - Lexmark E260dn Service Manual

4513-220, -230

Diagnostics mode selections

To enter the Diagnostics mode:
1.
Turn off the printer.
2.
Open the front access door.
3.
Turn on the printer while pressing and holding Cancel
4.
Close the front access door once the Error
Print the menu page by pressing and holding Continue
the menu page to access the menu items shown in the table below.
Menu item
Prt Quality Pgs
Edge to Edge
Defaults
Cont Prt Simplex Tray 1
Cont Prt Duplex Tray 1
Cont Prt Simplex Tray 2
Cont Prt Duplex Tray 2
Print History
Configuration ID
Printer alignment
3-8
Lexmark™ E260d, E260dn
Print test pages by pressing and holding
Help isolate print quality problems, such as streaking. Four pages print:
A text page with printer information, cartridge information, current margin settings,
and a graphic.
Three pages all gray, all black, and the last one blank.
Cartridge lockout function is disabled.
Allow a shift of all four margins (top, bottom, right, and left) to the physical edge of
the page (printable area of supported paper).
Setting is ignored by PPDS interpreter.
Change sizes and designations to metric.
Continuously print pages containing cross lines, printer information, and margin
settings.
Press and hold until the lights flash to begin.
Press to stop.
Continuously print pages containing cross lines, printer information, and margin
settings.
Press and hold until the lights flash to begin.
Press to stop.
Continuously print pages containing cross lines, printer information, and margin
settings.
Press and hold until the lights flash to begin.
Press to stop.
Continuously print pages containing cross lines, printer information, and margin
settings.
Press and hold until the lights flash to begin.
Press to stop.
Print history of errors.
Press and hold until the lights flash to print.
Allow the printer ID to match the label ID after the controller board is replaced.
Align a new printhead. See
page 3-9 for more information.
.
light displays.
until all of the lights flash. Follow the instructions on
Use setting to
until the lights flash.
"Printhead assembly mechanical adjustment" on
Value
None
Off
(default)
On
U.S.
(default)
Non-U.S.
None
None
None
None
None
000101
(default)
000189
None