Ordering a photoconductor kit ........................... 5 Replacing supplies.............................6 Replacing the toner cartridge ..........................6 Replacing the photoconductor kit ........................8 Recycling Lexmark products........................11 Moving the printer..........................11 Before moving the printer ..........................11 Moving the printer to another location......................11 Shipping the printer ............................11...
Maintaining the printer Periodically, certain tasks are required to maintain optimum print quality. Cleaning the exterior of the printer Make sure that the printer is turned off and unplugged from the wall outlet. CAUTION—SHOCK HAZARD: To avoid the risk of electric shock when cleaning the exterior of the printer, unplug the power cord from the wall outlet and disconnect all cables to the printer before proceeding.
To access printer menus: • Open the Embedded Web Server by typing the printer IP address into the address field of your Web browser. Note: If you do not know the IP address of the printer, print a network setup page and locate the IP address in the TCP/IP section.
To order supplies in the U.S., contact Lexmark at 1-800-539-6275 for information about Lexmark authorized supplies dealers in your area. In other countries or regions, visit the Lexmark Web Site at www.lexmark.comor contact the place where you purchased the printer.
Part name Part number Photoconductor kit E260X22G Replacing supplies Replacing the toner cartridge Light sequence Toner is low ‑ On • ‑ On • When the “Toner is low” light sequence appears, or when you experience faded print, remove the toner cartridge. Firmly shake it side‑to‑side and front‑to‑back several times to redistribute the toner, and then reinsert it and continue printing.
Page 7
Press the button on the base of the photoconductor kit, and then pull the toner cartridge out using the handle. Unpack the new toner cartridge. Warning—Potential Damage: When replacing a toner cartridge, do not leave the new cartridge exposed to direct light for an extended period of time.
Replacing the photoconductor kit The printer notifies you when the photoconductor kit reaches a page maximum. The printer does this by displaying the “Photoconductor life warning” light sequence or the “Replace photoconductor” light sequence. Light sequences Photoconductor life warning ‑ Blinking ‑...
Page 9
To replace the photoconductor kit: Open the front door by pressing the button on the left side of the printer and lowering the front door. Pull the photoconductor kit and toner cartridge together as a unit out of the printer by pulling on the toner cartridge handle.
Page 10
Insert the toner cartridge into the photoconductor kit by aligning the rollers on the toner cartridge with the tracks. Push the toner cartridge in until it clicks into place. Install the unit into the printer by aligning the arrows on the guides of the unit with the arrows in the printer. Push the unit as far as it will go.
Recycling Lexmark products To return Lexmark products to Lexmark for recycling: Visit our Web site at www.lexmark.com/recycle. Find the product type you want to recycle, and then select your country from the list. Follow the instructions on the computer screen.