4513-220, -230
Service tertiary error codes
Service tertiary error codes
Service error codes are generally non-recoverable except in an intermittent condition when POR (power-on
reset) is performed which allows the printer to temporarily recover from the error. These error codes are
recorded in the history file which can be reviewed through the Diagnostics Menu. See
selections" on page
Note: All service errors are initially communicated by all lights flashing which is the primary indication or code.
For brevity, this indication is not repeated in the following codes.
CAUTION: When this symbol appears, there is a danger from hazardous voltage in the area of the
product that is being worked on. Unplug the product before beginning, or use caution if the product
must receive power in order to perform the task.
Controller software
Codes 90x indicate a controller software error/illegal trap. For the other errors, which indicate a faulty programming process
or faulty component on the controller board, replace the controller board. See
Service tertiary error codes: controller software
Lights
Service secondary codes: 90x
Service tertiary codes
900: Service RIP software error
901: Service engine flash error
902: General engine software error
903: Service engine software error
904: Service engine software error
905: Interface violation by paper
port device
906: Service engine software error
Service watchdog: 90x
901: Timer service slow
2-30
Lexmark™ E260d, E260dn
3-8.
✷
✷
✷
✷
✷
✷
✷
✷
"Diagnostics mode
"Controller board removal" on page
✷
✷
✷
✷
✷
4-6.
✷
✷
✷
✷
✷
✷
✷
✷
✷
✷