Table of Contents
Advertisement
C@nnecti@ns
Setup
Why You Should Connect This G-LINK Cable
The G-LINK cable enables the G[ I1)E I It s+ system (the on-screen
interactive program guide) to
work with your VCR and/or cable box.
Cable Box - It your TV is connected
to a cable box you must connect the G-LINK cable to receive
TV program listings tbr your area, and to rune directly to a channel when the program guide is on
your TV screen.
¥CR-
If your TV is connected
to a VCR and you don't connect the G-LINK cable, one-touch
VCP,
recording
won't work. The other teatures ot the guide will work properly.
G-LINK wands
How to Find the Remote
Sensor
You have to place the G-LINK wands in front of the remote sensor on the VCR and/or cable box.
Some cable boxes and VCRs have the remote sensor labeled on the unit. If the remote sensor isn't
labeled on your VCR and/or
cable box, you need to use the remote control that came with the VCR
and/or cable box to locate the sensor.
1.
Turn off the VCR and/or cable Ix)x.
2.
Hold the remote control (not the one that calne with your TV, but the one that came with the
cable box and/or VCR to which you're attaching the G-LINK cable) so that it is touching
the
front of the component.
3.
Slowly move the remote control across tile front of the component
(VCR or cable box) while
you press the power button on and off. You must press and release the power button each time
you move the remote (holding down the button won't work).
4,
When the component
turns on, you've located the remote sensor.
If you don't have both a
cable box and a VCR
connected
to your TV,
just coil the cable of the
extra G-LINK wand with
a twist tie and leave it
behind the T_
Placing the G-LINK Wands
?
Place the G-LINK wands in front ot the remote sensor on your \ CP, and/or cable box approximately
one inch away troln the remote sensor (see instructions
below).
IV (back pallel)
---
///I
ILI
...... -I
Chapter I
13
Advertisement
Table of Contents
Troubleshooting
