RCA F20648TX51M9 User Manual page 20

C@nnecti@ns Setup
Step 3: Configuring for a VCR
1. I1 your TV is connected to a VCR, press OK.
I1 it is not, highlight N0 and press OK (a screen will appear reminding you
to connect your G-LINK cable to your TV and VCR.).
2. Use the tip and down arrow buttons to highlight tile brand of your VCP, that
is connected to the TV and press OK.
II your brand isn't listed, highlight Not Li._tecland press OK.
3_
Tune your VCR to channel 02. Next, turn OFF your VCtL When you
complete these steps, press OK to begin testing.
Important Note: When code te.;ting i._in pro,gre.;s, do_ 't toz_ch yoz_r 7'_
VCR, or a_zy q/'t,Se remote controtsjbr t,Sese products.
f
Look at the front display of your VCR. If your _ Ct{ turned on automatically
and changed to channel 09, the test was successful. Highlight Yes"and
press OK.
If your VCR didn't change to channel 09, you can either choose NO or 7bst
this code a_,dahz.
If you think your TV or remotes might have been touched during tile test,
7 •
tune your VCP, to channel 02, turn ofl your \ CP, and highlight 7?<vtthis
code again.
If you don't think the test was interrupted, highlight 3/0. Tune your VCR to
channel 02 and turn off your VCtL Press OK (the GUIDE Plus+ system starts
testing another set of codes.)
Keep lk)lk)wing tile previous instructions until the VCR tinds the
correct code.
18 Chapter I