Table of Contents
Advertisement
Connections
S ' up
Why You Should Connect This G-LINK Cable
The G-LINK cable enables the GUIDE Plus+ system (the on-screen
interactive program guide)
to work with your VCR and/or cable box.
Cable Box - If your "IN is connected
to a cable box you must connect the G-LINK cable to
receive TV progrmtr_ listings for your area, and to tune directly to a channel when the program
guide is on your TV screen.
¥Cll-
If your TV is connected
to a VCR and you don't connect
the G-LINK cable, one-touch
VCR recording
won't work. "II_e other features of the guide will work properly.
2.
G-LINK wands
How to Find the Remote
Sensor
You have Io place lhe G-LINK wands in front of the remote sensor on the VCR and/or
cable box.
Some cable boxes and VCRs have lhe remote sensor labeled on the unil. If the remote sensor isn't
labeled on your VCR and/or
cable box, you need to use the remote control that came with the VCR
and/or cable box to locate the sensor.
1.
Turn olt" lhe VCR and/or cable box.
Hold lhe remote conlrol (not lhe one that came will] your "IN, but the one that came will] the
cable box and/or VCR to which you're at"taching lhe G-LINK cable) so that it is touching
the
front of lhe component.
3.
Slowly move the remote control across the l¥ont of lhe component
(VCR or cable box) while
you press the power button on and off'. You must press and release the power button each time
you move the remote (holding
down the button won't work).
II
II
4.
When lhe component
turns on, you've located lhe remote sensor.
Tip
If you don't have both a
cable box and a VCR
connected to your T_, just
coil the cable of the extra
G-LINK wand with a twist
tie and leave it behind the
T_
Placing the G-LINK Wands
Place the G-LINK wands in front of the remote sensor on your VCR and/or cable box approximately
one inch away from the remote sensor (see instructions
below).
TV(l_ack panel)
13
Advertisement
Table of Contents
