Connection: Tv + Vcr + Cable Box - RCA F20648TX51M9 User Manual

C@nnecti@ns Setup
From CableLine
SIGNAL SPLITTER
CABLEBOX
TV
_CA_LE/
®
Note: 7be GUI1)E l_tus+ syslem g O_e- Tbucb VCR Recorcling j_alure is not available with lbL_
connectio_t, i/'you wa_tt to use the O_te Timcb VCR Recordingj_ature with your cabh, box, you
must use Ibe TV and VCR connection on page 8. You can do so by rout#zg the sig_mlji_Jm your
cabh, box into the antenna input o_l your VCR. Note that PIP wolff work (/'you use tbi_
connectio_z. 7his connectio_l may _lot be compatible with all cable se!Tdces, especially, (/'some or
all cable cbamleL_ are scrambled.
Connection: TV + VCR + Cable Box
1.
2.
Connect Signal Splitter to your VCR and TV
A. [sea Signal Splitlur (not provided) to split the signal coming into the room. You can purchase
a Signal Splitwr aE your local electronics store or through the Accessory Order Form on
page 59.
B. Connect a coaxial cable to Signal Splitter and to the Input Jack on the VCR (sometimes labeled
ANTENNA IN).
C. Connect a coaxial cable to the Signal Splitwr and to the CABLE IN Jack on the cable box.
Connect Cable Box to TV
Connvct a coaxial cable to the TV OIT Jack on the cable box and to the CABLE/ANTENNA jack
on the TV.
.
.
Connect the TV to your VCR
A. Connect the audio cables (white and red) to the AUDIO IN jacks on the TV and to the Audio
Output Jacks on the VCR (sometimes labeled ALDIO OUT R and L).
B. Connect the video cable (yellow) to the VIDEO IN jack on the TV and to Video Output Jack on
the VCR (sometimes labeled VIDEO).
Connect G-LINK cable
A. If you haven't already done so, remove the Demo Pin from the G-LINK jack on the TV.
B. Connect the G-LINK cable to the G-LINK jack on the TV. Next step, place the wands of the
G-LINK cable to work with the VCR and cable box (instructions are on p. 13).
Go to page 13
12 Chapter I