Table of Contents
Advertisement
C@nnecti@ns
Setup
Why You Should Connect This G-LINK Cable
The G-LINK cable enables the GUIDE Plus+ system (the on-screen
interactive
program guide) to
wnrl,: with your VCR and/or cable box.
Cable Box-
If your TV is connected
to a cable box you must connect the G-LINK cable to
receive TV prograln listings tnr your area, and to tune directly to a channel when the program
guide is on your TV screen.
"VCII- It your TV is connected
to a VCR and you don't connect the G-LINK cable, one-touch
recording
won't work. The other l_,atures of the guide will work prnperly.
G-LINK cable
G-LINK wands
How to Find the Remote
Sensor
YOUhave to place the G-LINK wands in front of the remora, sensor on the VCR and/or cable box.
Some cable boxes and VCRs have the remote sensor labeled on the unit. If the remote sensor
isn't labeled on your VCR and/or cable box, you need to use the remote control that came with
the VCR and/or
cable box to locate the sensor.
].
2.
.
Turn off the VCR and/or cable box.
Hold the remote control (not the one that came with your TV, but the one that came with
the cable box and/or VCR to which you're attaching the G-LINK cable) so that it is touching
the front of the component.
Slowly move the remote control across the front of the component
(VCR or cable box) while
you press the power bumm on and off, You must press and release the power button each
time you move the remote (holding
down the button won't work).
II
II
4.
When the component
turns on, you've located the remote sensor.
If you don't have both a
cable box and a VCR
connected
to your TV,
just coil the cable of the
extra G-LINK wand with a
twist tie and leave it
behind the T_
Placing the G-LINK Wands
Place the G-LINK wands in front of the remote s{,nsnr on your VCR and/or
cable box
approximately
one inch away []c<)in the remote sensor (see instructions
below).
l]/(13ack lJanel)
....
@ .%%
Connect to G-LINK jack
on the back of the TY,
__
Chapter I
13
Advertisement
Table of Contents
