RCA F20648TX51M9 User Manual page 19

,
Highlight the channel to which you have to tune your TV in order to see
cable programming, and press OK (a screen appears reminding you lo
connect your G-LINK cable to your TV and cable box).
Notes: Channel Q$ i_ the most common.
Choose VideoJ/AUX (/'your cable box is connected to your TV with
aJ_dio/_'icleo cable._ instead o/'a coaxial cable. Go to page 7.fi2r pictures o/'
these cable._.
For more #_/brmation, go to cable box connection on page 12.
4. Highlight your brand of cable box, and press OK.
If your brand isn't listed, highlight Not Li_lecl and press OK.
5,
Make sure your cable box is on.
Tune tile cable box to channel 02 (use tile remote control that came with
your cable box, or press tile channel buttons on the cable box).
Press OK (tile GUIDE Plus+ system starts testing codes).
Important Note: When code testing is irt p_'%{4ress, don't touch your TK
VCR, cable box or a_ O, (?/'the remote control<fi)r tbese products.
,
Look at your cable box. If it is still on and changed to channel
09,
tile rest
was successful. Highlight Yes, and press OK ($7t_P_:3: Cot_/i_utqn/4jbr a VCR
appear.9.
If your cable box didn't change to channel (}9 or turned itself off, you have
hVo choices: No and 7&vttbi._ code again.
7k, st this code again: If you think tile TV, the cable box, or any of lhe
remote controls might have been louched or bumped during the test,
highlight Te._tthis code c<,4ainand press OK (the GLIDE Plus+ system runs
the salne set of codes).
No: If you don't think the test was interrupted, highlight No and press OK
(GUIDE Plus+ system tesls tile next code).
Repeat tile previous instructions until the TV finds tile correct cable box
code. Folk)w the instructions on the screen.
Note: I/'tbe TV can 't find your cable box code, a trouble._booti*<,4
cbec/eli._t appem:_. Car@dlF rcv_'ieu eacb cbecklist andjbltow the
instrzlctions on the screetL
Chapter I 17