Programming The Remote To Operate Other Components; Find Out If You Need To Program The Remote; How To Program The Remote - RCA F20648TX51M9 User Manual

Using Re @ e C@n r@M
You'll usethese buttons when you program the
remote to operate another component.
The remote may not operate all models of
all brands.
Programming the Remote to Operate
Other Components
"File universal remote control can be progranlmed to operate nlost brands
of remote controllable VCRs, satellite receivers and cable boxes. "File
remote is already programmed to operate most RCA, GE and PROSCAN
TVs, VCRs, DVD players, laserdisc players and satellile receivers.
Find Out If You Need to Program the Remote
To determine whether tile universal remote needs to be programmed,
turn a component ON, such as a VCR, point tile remote at tile VCR, and
press tile VCR1 button. Then press ON-OFF or channel kip or channel
down to see if tile VCR responds to tile remote commands. If not, tile
r(,n:ot(,ne('ds
to be progra:nmt, d_
How to Program the Remote
There an, two ways to progranl tile renlote
control:
automatic cod(.
search and direct entry. Instructions fk_r both ways follow.
rip
To stop the automatic code search without
programming any components, press and hold CLEAR
until the light on the remote turns off.
Using Automatic Code Search
1. Turn on the, component you want the, remote to operate (VCR, DVD
Player, etc.)
2,
Press and hold tile conlponent button on tile renlote control that
corresponds to tile component you want tile remote to operate
(VCR1, DVD, etc.). While you hold down tile component button,
press and hold ON-OFF (when tile red light on tile remote turns
on, release both buuons).
3. Press PLAY (tile red light on tile remote, located below tile ON-OFF
button, starts flashing).
7lie remote is searching tile first set of component codes (there are
20 sets of codes). If tile component you want to operate doesn't
turn off automatically afl(.r 5 seconds, press PLAY again (tile red
light starts flashing again as tile remote searches through tile next
set of codes).
Continue pressing PLAY until tile component turns off.
4,
Note: If the componer_t doesn '! tz¢rn ojff'q/?er yo*¢'¢,epressed the
I)IMY bz_tto_ 20 time._; the component can't be programmed.
Press REVERSE, w.ait 2 seconds. Repeat this sl(.p until tile
component turns back on.
5. 7b finish, press and hold tile STOP button until the red light on the
remote turns off.
24