Why You Should Connect This G-Link Cable; How To Find The Remote Sensor; Placing The G-Link Wands - RCA F32444 User Manual

Connections Setup
¢
G-LINK wands
Why You Should Connect This G-LINK Cable
The G-LINK cable enables the GUIDE Plus+ system (the on-screen interactive
program guide) to work with your VCRand/or cable box.
Cable Box - If your IV is connected to a cable box you must connect the G-LINK
cable to receive IV program listings for your area, and to tune directly to a channel
when the program guide is on your "!V screen.
VCR - If your IV is connected to a VCR and you don't connect the G-LINK cable,
one-touch VCR recording won't work, The other features of the guide will work
properly
How to Find the Remote Sensor
You have to place the G-LINK wands in front of the remote sensor on the VCR and/or cable box. Some cable
boxes and VCRs have the remote sensor labeled on the unit. If the remote sensor isn't labeled on your VCR
and/or cable box, you need to use the remote control that came with the VCR and/or cable box to locate the
sensor.
1. Turnoff the VCRand/or cable box,
2. Hold the remote control hot the one that came with your IV, but the one that came with the cable box
and/or VCR to which you're attaching the G-LINK cable) so that it is touching the front of the component.
3. Slowly move the remote control across the front of the component (VCR or cable box} while you press the
power button on and off. "flu must press and release the power button each time you move the remote
(holding down the button won't work).
4. When the component turns on, you've located the remote sensor
IV (backp_el)
Placing the G-LINK Wands
Place the G-LINK wands in front of the remote sensor on your
VCR and/or cable box approximately one inch away from the
remote sensor.
Turn on the TV
Press the IV button on the remote control or the POWER button on the IV (the first screen of the Interactive
Setup appears). The menu screens "time out" after a period of time if you don't make a selection_Taecess the
setup menus manually pres MENU and choose the SETUP option.
Note: Pressing the IV button not only turns on the W, but puts the remote into Iv mode. "IV mode" meons that
the buttons on the remote control operate the W's functions.
Chapter I 5