Viewingthe Picturecoming From Yourvcr - Mitsubishi HS-U110 Owner's Manual

ffyouused thiscode
button tosetup
your r emote...
1
2
3
4
5
6
7
8
9
0
ENTER
CANCEL
INPUT
DISPLAY
VOLUME _,,
... then theDISPLAY
buttonwill worklike
this button...
... andthe INPUT
buttonwill v like
thisbuttc
DISPLAY INP!
-- TVNIE
DISPLAY TVNIE
DISPLAY
DISPLAY
RECALL "FVNI[
_ECALL TV/V"
DISPLAY AU;
-- TVNI[
DISPLAY TVNI[
DISPLAY
DISPLAY TV/V
DISPLAY TV/VI[
DISPLAY "I-VNI[
... andthe ENTER
buttonwil worklike
this button...
ENTER
100
ENTER
ENTER
ENTER
1C,O
IC,O
ENTER
1O0
ENTER
ENTER
[>Important:
_Important:
When you replace the batteries in your remote, the remote will
return to its initial setting (code button "1"). _epeat the steps
above to reset your remote control.
operating yourTVwith theHS-U110 remotecontrol
O Press the TV button on the HS-Ull0 remote control.
O Point the remote control towards the remote sensor on the TV
and press the desired buttons.
O To once again control the VCR, press the VCR button.
Because of variations among models, some or all buttons may not
work, or they may operate different functions than listed above,
for your particular TV. If this occurs, you may need to use your
TV remote control.
Viewingthe PictureComing from YourVCR
This is the most important part of using your VCR, but often the
most confusing: how d.o you view a picture coining from the VCR?
Beforeyou begin, youshouldknow:
• whether
you are viewing a "Monitor '1_ r" or a "Regular TV."
(See page 19.)
This section teaches you about::
• Viewing the picture coming from your VCR if you are using
a regular TV, and
• Viewing the picture coming from your VCR if you are using
a monitor TV.
21