Viewing The Picturecoming From Yourvcr - Mitsubishi HS-U260 Owner's Manual

Chapter 3: Operating YourVCR Using the Remote Control(cont.)
If youused thiscode ... then theDISPLAY ... andtheINPUI" ... andtheENTER
button tosetup button willwork like. button willwo like button wil_)rk like
yourremote.., thisbutton.., thisbutton thisbutton...
1 DISPLAY INPUI' ENTER
2 -- TV/VIDE m
3 DISPLAY W/VIDE 100
4 DISPLAY -- ENTER
5 DISPLAY -- ENTER
6 RECALL TV/VIDE --
7 RECALL TVNTI ENTER
8 DISPLAY AUX 100
9 -- TV/VIDE
0 DISPLAY TVNIDE 100
ENTER -- m ENTER
CANCEL DISPLAY -- 100
INPUT DISPLAY TV/VTt ENTER
DISPLAY DISPLAY TV/VIDE ENTER
VOLUME • DISPLAY TVNIDE --
_Important:
[_Important:
When you replace the batteries in your remote, the remote vdll
return to its initial setting (code button "1"). Repeat the steps
above to reset your remote control.
operating yourTV withtheHS-U260 remote control
O Press the TV button on the HS-U260 remote control.
Point the remote control towards the remote sensor on tihe TV
and press the desired buttons.
To once again control the VCR, press the VCR button.
Because of variations among models, some or all buttons may not
work, or they may operate different functions than listed above,
for your particular TV. If this occurs, you may need to use your
TV remote control.
Viewing the PictureComing from YourVCR
This is the most important
part, of using your' ¥CR, but often the
most confusing: how do you view a picture coming from the VCR?
Beforeyou begin,youshouldknow:
• whether
you are viewing a "Monitor TV" or a "Regular
'I_."
(See page 18.)
This section teaches you about:
• Viewing the picture coming from your VCR if you are using
a regular TV, and
• Viewing the picture coming from your VCR if you are using
a monitor TV.
2O