Table of Contents
Advertisement
Chapter 3: Operating YourVCR
Usingtl'e RemoteControl ( cont.)
_Important:
Because
of variations
among
models,
some or all buttons
may not
work, or they may operate
different
functions
than
listed, for your
particular
TV. If this occurs, you may need to use your TV remote
control.
Viewingthe PictureComingfrom YourVCR
This is the most important
part of using your VCR, but often the
most confusing:
how do you view a picture
coming from the VCR?
Before you begin, you should know:
• whether
you are viewing
a "Modern
TV" or an "Older TV."
(See page 17.)
Viewingthe picture comingfrom your VCR i! you are using an
older TV
O
Turn on your TV and tune it to channel
3 or 4.
Io o -=¢D.A
i®@®_il
ffl_EI
O
Turn on the VCR by pressing
the POWER
button.
Check to see if the '_VCR" light on the front panel display
is
lit. If it is not lit, press
the VCR/TV buttor
until it is lit.
You are viewing the picture
from your VCRI
With this set-up,
you will use the VCR/TV butLon when recording,
when viewing
tapes or broadcast
stations
through
your VCR, or
before using the VCR's menus.
You also use tl: e VCR!TV button
to switch
back to normal
TV viewing.
_Important:
If you set the "RF converter"
setting
of the
,u s_om_ze choices
menu to ON, you don't need to use the VCR/TV button
when
viewing
tapes. (See page 48. )
Viewingthe picturecoming from your VCR if you are using a
modernTV
0
Turn on your TV and switch
it to the corre :t external
input.
(For most Mitsubishi
TVs, this means
pressing
the TV's;
INPUT
button
until you see the words "ExL-I" or "Input-l"
on
the screen.)
Turn the VCR on by pressing
the POWER
button.
You are viewing
the picture
from your VCR!
If you wish to return
to normal
TV viewing,
,_witch your TV's
input back to its previous
position.
L>Important:
If you are using a modern
TV, be sure to set Lhe "RF converter"
of
the "Customize
choices" menu i:o OFF to prevent
noise in the
picture.
(See page 48. )
20
Advertisement
Table of Contents
