Table of Contents
Advertisement
Lower the treadmill (see HOW TO LOWER THE
TREADMILL FOR USE on page 28). Remove the
three #8 x 3/4" Screws (1). Carefully pivot the Motor
Hood (71) off.
71
Locate the Reed Switch (52) and the Magnet (50)
on the left side of the Pulley (49). Turn the Pulley
until the Magnet is aligned with the Reed Switch.
Make sure that the gap between the Magnet and
the Reed Switch is about 1/8 in. (3 ram). If neces-
sary, loosen the #8 x 3/4" Tek Screw (13), move
the Reed Switch slightly, and then retighten the
Screw. Reattach the Motor Hood (not shown) with
the five #8 x 3/4" Screws (not shown) and run the
treadmill for a few minutes to check for a correct
speed reading.
Top
View
1/8 in..
52-
13-
-_ 50
---49
PROBLEM:
The incline of the treadmill
does not change correctly
SOLUTION:
a. Recalibrate the incline system (see step 3 on page 25).
PROBLEM:
The walking
belt slows when walked on
SOLUTION:
a. Use only a single-outlet surge suppressor that meets all of the specifications described on page 14.
b.
If the walking belt is overtightened, treadmill perfor-
mance may decrease and the walking belt may be-
come damaged. Remove the key and UNPLUG
THE POWER CORD. Using the hex key, turn both
idler roller bolts counterclockwise,
1/4 of a turn.
When the walking belt is properly tightened, you
should be able to lift each edge of the walking belt
2 to 3 in. (5 to 7 cm) off the walking platform. Be
careful to keep the walking belt centered. Then,
plug in the power cord, insert the key, and run the
treadmill for a few minutes. Repeat until the walking
belt is properly tightened.
Idler Roller Bolts
c. If the walking belt still slows when walked on, see the front cover of this manual.
30
Hide quick links:
Advertisement
Table of Contents
