Table of Contents
Advertisement
12. Remove the packaging material from the bottom
of the Frame (56). See the inset drawing.
Make
sure that the 1/2" Rear Foot Nuts (111) are
threaded all the way onto the Rear Feet (60).
Turn the two Rear Feet all the way into the
Frame.
See step 10. Discard the piece of cardboard.
Lower the Frame (56) (see HOW TO LOWER
THE TREADMILL FOR USE on page 28).
If one of the Rear Feet (60) doesn't sit flat on the
floor, turn the Rear Foot until it does and then
tighten the 1/2" Rear Foot Nut (111) against the
Frame (56).
12
13. Press the Grommet (81) into the square hole in
the Base (97).
13
81
97
14. Make sure that all parts are properly tightened
before you use the treadmill.
If there are sheets of plastic
on the treadmill decals, remove the plastic, To protect the floor or carpet, place a mat under the treadmill,
Note: Extra hardware may be included, Keep the included hex keys in a secure place; one of the hex keys is
used to adjust the walking belt (see pages 30 and 31).
12
Hide quick links:
Advertisement
Table of Contents
