Table of Contents
Advertisement
TROUBLESHOOTING
Most treadmill
problems
can be solved by following
the simple steps below. Find the symptom
that
applies, and follow the steps listed, if further assistance
is needed, see the front cover of this manual.
PROBLEM:
The power does not turn on
SOLUTION:
a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor
is plugged into a properly grounded outlet (see page 14). Use only a single-outlet surge suppres-
sor that meets all of the specifications described on page 14. iMPORTANT:
The treadmill
is not
compatible
with GFCl-equipped
outlets
and may not be compatible
with AFCl-equipped
outlets.
b. After the power cord has been plugged in, make sure that the key is inserted into the console.
C.
Check the power switch located on the treadmill
frame near the power cord. If the switch protrudes
as shown, the switch has tripped. To reset the
switch, wait for five minutes and then press the
switch back in.
PROBLEM:
The power turns off during
use
Tripped_
Reset_
SOLUTION:
a. Check the power switch (see the drawing above). If the switch has tripped, wait for five minutes
and then press the switch back in.
b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for
five minutes, and then plug it back in.
c. Remove the key from the console. Reinsert the key into the console.
d. If the treadmill still will not run, please see the front cover of this manual.
PROBLEM:
The console displays
remain lit when you remove the key from the console
SOLUTION:
a. The console features a display demo mode, designed to be used if the treadmill is displayed in a
store. If the screen shows a preset presentation when you remove the key, the demo mode is
turned on. To turn off the demo mode, hold down the Stop button for a few seconds. If the demo
mode is still on, see step 5 on page 24 to turn off the demo mode.
PROBLEM:
The displays
of the console do not function
properly
SOLUTION:
a. Remove the key from the console and UNPLUG
THE POWER CORD. Place the treadmill in the stor-
age position (see HOW TO FOLD THE TREADMILL
on page 28).
1
Next, remove the two indicated #8 x 3/4" Screws
(1).
29
Hide quick links:
Advertisement
Table of Contents
