KitchenAid K45SSWH Instructions And Recipes Manual page 11

Assembling Your 5 Quart Mixer
TO ATTACH BOWL
1. Be sure speed control is
OFF
and
mixer is unplugged.
2. Place bowl lift handle in down
position.
3. Fit bowl supports over locating
pins.
4. Press down on back of bowl until
bowl
pin
snaps into
spring
latch.
5. Raise bowl before mixing.
G. Plug mixer in proper electrical outlet.**
TO REMOVE BOWL
1. Be sure speed control is
OFF
and
mixer is unplugged.
2. Place bowl lift handle in down
position
3. Remove flat beater, wire whip, or
dough hook.
4. Grasp bowl handle and lift straight
up and off locating pins.
....... _--_a_.
TO ATTACH FLAT BEATER,
WIRE WHIP, OR DOUGH HOOK
1. Turn speed control to OFF and
unplug.
2. Slip flat beater on beater shaft and
press upward as far as possible.
3. Turn heater to
right, hooking
beater over the
pin on shaft.
4. Plug mixer in proper electrical outlet.**
TO REMOVEFLAT BEATER,
WIRE WHIP, OR DOUGH HOOK
1.Turn
speed control to
OFF
and
tmplug.
2. Press beater upward as far as
possible and ttlrn left.
3. Pull beater fl'om beater shaft.
4. Plug mixer in proper electrical outlet.**
SE
TO RAISE BOWL
1. Rotate handle to straight-up position.
2. Bowl must always be in raised,
locked position when mixing.
TO LOWER BOWL
1. Rotate handle back and down.
Injury Hazard
Unplug mixer before inserting
or removing beaters.
Unplug mixer before cleaning.
Failure to do so can result in
broken bones or cuts.
HOUSEHOLDMIXER
SPEED CONTROL
Ping mixer in proper electrical outlet.**
Speed coim-ollever should always to be
set on lowest speed for ,starting,then
gradually moved to desired higher speed
to avoid splashing ingredients out of bowl.
See pages
14, 18
for Speed Control Guide.
OVERLOAD RESET BUTTON
Models KSM50P and
KSMC50 only
If the mixer is overloaded,
the Overload Reset Button
will pop out and the mixer will shut off.
Turn the Speed Control Lever to
OFF.
\/gait a few minutes, then push in the
Reset Button. Turn the Speed Control
Lever to the desired speed and continue
mixing.
** See page 6,