Troubleshooting - Zoom G5 Operation Manual

Troubleshooting

No sound or very low volume
• Confirm that the POWER switch is set to
"ON".
• Check the connections (
• Adjust the patch level (
• Adjust the master level (
• W hen adjusting the volume with the
Z-Pedal / an expression pedal, make sure
that a suitable volume setting has been set
with the pedal.
• Confirm that unit is not in mute mode
( → P24).
There is a lot of noise
• Check shielded cables for defects.
• Use only a genuine ZOOM AC adapter.
The sound distorts strangely/has an odd timbre
• Set the OUTPUT parameter according to
the output equipment (
• Set the ACTIVE/PASSIVE switch according
to the type of guitar pickups or the device
connected directly to the
• If you are using the TUBE BOOSTER,
lower the Boost level. (
62
→ P4–5).
P18).
→
→ P20).
P23).
→
( P5).
→
→ P34).
An effect is not working
• I f t h e ef fe c t p ro c e s s i n g c a p a c i t y i s
exceeded, "DSP FULL" appears on the
effect graphic. In this case, the effect is
bypassed ( P10).
→
The Z-Pedal is not working well
• Check the Z-Pedal settings (
• Adjust the Z-Pedal (
The recorded level in a DAW is low
• Check the recording level setting (
→ P12).
P38).
→
→ P22).