Z-Pedal Effect Types And Parameters - Zoom G5 Operation Manual

Z-Pedal Effect Types and Parameters

Z-Pedal Effect Types and Parameters
#1 VolBoostZ This effect provides a clean boost without changing frequency characteristics.
Page01
Page02
Page03
#2 Filter-Z The cut-off frequency and resonance of this filter effect can be controlled using the pedal.
Page01
Page02
#3 Tremolo-Z The depth and rate of this tremolo effect can be controlled using the pedal.
Page01
Page02
#4 Flanger-Z The mix and rate of this flanger effect can be controlled using the pedal.
Page01
Page02
#5 Echo-Z The time and feedback of this echo effect can be controlled using the pedal.
Page01
Page02
The rotation speed and width of this rotary speaker simulation can be controlled using
#6 Rotary-Z
the pedal.
Page01
Page02
Knob1
VPosi 0–100 P HPosi
Sets the starting position value.
After the pedal is moved, the actual
position value is used.
LEFT 10–300
Sets the volume when pushed all
the way left.
Level 0–150
Sets the output level.
Knob1
Freq 0–100 P Reso
Sets the cut-off frequency.
Level 0–150
Sets the output level.
Knob1
Depth 0–100 P Rate
Sets the modulation depth.
UP 0–UP 9,
Wave DWN 0–DWN 9,
TRI 0–TRI 9
Sets the waveform used for
modulation.
Knob1
Mix 0–100 P Rate
Sets the volume of the effect
compared to the source sound.
PreD 0–50
Sets the pre-delay time of the effect
sound.
Knob1
Time 50–650 P F .B
Sets the delay time.
HiDMP 0–10
Sets the attenuation of the high
frequencies in the delay sound.
Knob1
Speed 0–100 P Width
Sets the rotation speed.
Level 0–150
Sets the output level.
Knob2
L100–CNTR–R100 P Curve
Sets the starting position value.
After the pedal is moved, the actual
position value is used.
CNTR 10–300
Sets the volume when in the center
position.
Knob2
0–100 P Bal
Sets the resonance of the filter.
Knob2
0–100 P Level
Sets the modulation speed.
PSync OFF ,ON
When ON, the rate value adjusted
by pedal horizontal operation will be
synchronized to tempo.
Knob2
0–100 P Depth
Sets the modulation speed.
PSync OFF ,ON
When ON, the rate value adjusted
by pedal horizontal operation is
synchronized to tempo.
Knob2
0–100 P Mix
Sets the feedback amount.
PSync OFF ,ON
When ON, the time value adjusted
by pedal vertical operation will be
synchronized to tempo.
Knob2
0–100 P Bal
Sets the width of the high
frequencies.
Drive 0–100
Sets the amount of amplification of
the preamp.
Knob3
Slow1,Slow2,
NRML,Fast
Selects the type of curve used for
vertical adjustments.
RIGHT 10–300
Sets the volume when pushed all
the way right.
Knob3
0–100
Sets the balance between source
and effect sounds.
Knob3
0–150
Sets the output level.
Knob3
0–100
Sets the modulation depth.
Level 0–150
Sets the output level.
Knob3
0–100
Sets the volume of the effect
compared to the source sound.
Level 0–150
Sets the output level.
Knob3
0–100
Sets the balance between the horn
(high frequencies) and drum (low
frequencies).
NEXT
59