Troubleshooting - Zoom G11 Operation Manual

Troubleshooting

The unit will not power on
• Confirm that the POWER switch is set to ON.
• Check the connections. ( →
There is no sound or output is very quiet
• Check the connections. ( →
• Adjust the levels of the effects. ( →
• Adjust the level of the patch memory. ( →
• Adjust the output volume. ( →
• If you are using an expression pedal to adjust the volume, adjust the pedal position until the volume level is
suitable.
• Confirm that the tuner output is not set to "MUTE". ( →
There is a lot of noise
• Confirm that a shielded cable is not the cause.
• Use a genuine ZOOM AC adapter. ( →
Effects are not working
• If the effect processing power is being exceeded, "PROCESS OVERFLOW" will appear on the display. When
"PROCESS OVERFLOW" appears for an effect, it will be bypassed. ( →
on page 26)
An expression pedal does not work well
• Select the pedal effect. ( →
• Check the expression pedal settings. ( →
• Adjust the expression pedal. ( →
• Confirm the setting of the connected pedal. ( →
The level recorded in the DAW is low
• Check the recording level setting. ( →
"Connecting" on page 17)
"Connecting" on page 17)
"Adjusting effects" on
"Setting the patch memory level" on
"Adjusting the overall volume" on
"Connecting" on
"Using the built-in pedal" on
"Using the built-in pedal" on
"Adjusting the pedal" on
"Using an external pedal" on
"Making audio interface settings" on
page 28)
page 19)
"Using the tuner" on
page 17)
"Number of effects in patch memories"
page 51)
page 51)
page 53)
103
page 37)
page 57)
page 55)
page 91)