Using The Pedal To Select The Patch - Boss GT-10 Owner's Manual

Chapter 1 Playing Sounds

Using the Pedal to Select the Patch

Patches are switched by selecting a "bank" (U01–U50, P01–P50) and "number" (1-4). The bank and number appear in the GT-10's
display as shown in the following figure.
fig.02-040d
Bank
fig.02-050
• When selecting a patch, even if a new bank is selected, the patch is not switched until you also choose the number. If you want to be able to switch patches
merely by selecting a different bank, adjust the Bank Change mode (p. 72) setting.
• You can also set the unit so certain effects continue to be used with a following patch after you switch patches. For details, refer to "Keeping Effect Sounds
Playing After Patches Are Switched (Patch Change Mode)" (p. 68).
Choosing a Patch in the Same Bank
1.
Choosing a Patch in a Different Bank
1.
2.
30
Bank Number
Number
Choose the number of the patch you want to use.
Select the bank.
Choose the number of the patch you want to use.
• The indicator for the selected number pedal
lights up.
• On the GT-10, you cannot switch patches in
any screen other than the Play screen. Press
[EXIT] to return to the Play screen (p. 24).
Press the BANK pedals to select the desired bank.
After bank selection, the GT-10 stands by for
specification of the patch number, and the number
pedal indicators light up.
• The indicator for the selected number pedal
lights up.
• On the GT-10, you cannot switch patches in
any screen other than the Play screen. Press
[EXIT] to return to the Play screen (p. 24).