Overview Of Phrase Loop Operation - Boss GT-10 Owner's Manual

Chapter 4 Playing Sounds
Parameter/ Explanation
Range
Pdl Mode (Pedal Mode)
The BANK pedals are not used for operation of the Phrase Loop feature. These are used as bank switch pedals.
Off
Phrase Loop can be controlled by assigning the Phrase Loop feature to any of the CTL pedals 1 through 4 and maintaining the BANK
pedals' bank switching function.
On The BANK pedals are used for operation of the Phrase Loop feature.
Rec Mode (Recording Mode)
Mono Phrases are recorded in mono (max. 38 seconds).
Stereo
Phrases are recorded in stereo (max. 19 seconds).
Play Lev (Play Level)
0–120 Sets the phrase playback volume.
Clear Pdl (Clear Pedal Function)
When you press [BANK ▲] while the Phrase Loop feature is on, the recorded data is cleared and then GT-10
Clear Only
switches to STANDBY mode.
When you press [BANK ▲] while the Phrase Loop feature is on, the performance of the recorded phrase is muted (the
recorded data is not erased).
Mute/Clear
If you then press [BANK ▲] again while the phrase is muted, the recorded data is cleared and then GT-10 switches to
STANDBY mode.

Overview of Phrase Loop Operation

When the PHRASE LOOP function and the Pdl Mode parameter are both set to "on," phrase loop operation is switched as shown
below.
When the Clear Pdl parameter is "Clear Only"
CLEAR
STANDBY
When the Clear Pdl parameter is "Mute/Clear"
CLEAR
STANDBY
60
REC
MUTE
REC
PLAY
PLAY
OVERDUB
OVERDUB