Usb; Driver Mode - Boss GT-10 Owner's Manual

Chapter 8 Parameters Guide
Parameter/ Explanation
Range
EXP1/EXP Sw/CTL1/CTL2/EXP2/CTL3/CTL4 Out
(Transmit Control Change)
This sets the controller number when the controller operation data
is output as Control Change messages.
Off, CC#1–CC#31,
Selects the controller.
CC#64 –CC#95
Map Select
This setting determines whether patches are switched according
to the Program Change Map settings, or to the default settings.
Switches to the patches according to the
Fix
default settings.
Switches to the patches according to the
Prog
Program Change Map.
PROGRAM MAP
When switching patches using Program Change messages trans-
mitted by an external MIDI device, you can freely set the corre-
spondence between Program Change messages received by the
GT-10 and the patches to be switched to in the "PROGRAM
MAP."
This sets the patch number (P01-1
Bank 0–3 /
through U50-4) for the corresponding
PC#1–PC#128
Program Change number.
BULK DUMP
On the GT-10, you can use Exclusive messages to provide another
GT-10 with identical settings, and save effect settings on a MIDI
sequencer or other device.
SYSTEM System Parameters
Quick Settings for User Quick Setting
Settings for Patch Number U01-1 through
U01-1–U50-4
U50-4
Settings for the patch that is currently
Temp
called up
140

USB

Parameter/ Explanation
Range

Driver Mode

This mode uses the OS's standard USB driv-
er.
Standard
You cannot use MIDI when Standard is
selected as the driver mode. If you want to use
MIDI with the USB connection, set the GT-10
to the advanced driver mode.
Advanced This mode uses the special driver.
Monitor Cmd (Monitor Command)
The Direct Monitor command is disabled,
Disable maintaining the Direct Monitor mode set
by the GT-10.
The Direct Monitor command is enabled,
Enable allowing the Direct Monitor mode to be
switched from an external device.
Dir.Monitor (Direct Monitor)
Set this to Off if transmitting audio data
internally through a computer (Thru).
Off
No sound is heard at this time unless the
setting for the computer is Thru.
The GT-10 sound is output. Set this to On
when using the GT-10 as a standalone de-
On vice, without connecting to a computer
(only USB input sound will be output if
this is set to Off).
• This setting cannot be saved. It is set to On when the power is turned
on.
• If you are using the special driver, you can control Dir.Monitor On/Off
from ASIO 2.0-compatible application.