Octave; Pitch Shifter - Boss GT-10 Owner's Manual

OCTAVE

This adds a note one octave lower, creating a richer sound.
Because of the need to analyze the pitch, chords (two or more sounds played
simultaneously) cannot be played.
Parameter/ Explanation
Range
Range
This selects the register to which the effect is applied.
B1 (corresponds to the sound of an open
Range 1 7th string) to E6 (corresponds to the 1st
string played at the 24th fret)
B1 (corresponds to the sound of an open
Range 2 7th string) to E5 (corresponds to the 1st
string played at the 12th fret)
B1 (corresponds to the sound of an open
Range 3 7th string) to E4 (corresponds to the
sound of an open 1st string)
B1 (corresponds to the sound of an open
Range 4 7th string) to E3 (corresponds to the 4th
string played at the 2nd fret)
Oct.Level (Octave Level)
Adjusts the volume of the sound one oc-
0–100
tave below.
DirectLev (Direct Level)
0–100 Adjusts the volume of the direct sound.
Chapter 8 Parameters Guide

PITCH SHIFTER

This effect changes the pitch of the original sound (up or
down) within a range of two octaves.
Parameter/ Explanation
Range
Voice
Selects the number of voices for the pitch shift sound.
One-voice pitch-shifted sound output in
1-Voice
monaural.
Two-voice pitch-shifted sound (PS1, PS2)
2-Mono
output in monaural.
Two-voice pitch-shifted sound (PS1, PS2)
2-Stereo
output through left and right channels.
PS1/PS2 (Pitch Shift)
Mode *1
Selection for the pitch shifter mode.
The response is slower in the order of
Fast, Medium ,
FAST, MEDIUM and SLOW, but the
Slow
modulation is lessened in the same order.
MONO is used for inputting single notes.
Mono
You may be unable to produce the intended
effect when playing chords (two or more notes
played simultaneously).
Pitch *1
Adjusts the amount of pitch shift (the
-24–+24
amount of interval) in semitone steps.
Fine *1
Make fine adjustments to the interval.
-50–+50 The amount of the change in the Fine 100
is equivalent to that of the Pitch 1.
PreDly (Pre Delay) *1
Adjusts the time from when the direct
0 ms–300 ms,
sound is heard until the pitch shifted
sounds are inputted. Normally you can
BPM –BPM
leave this set at 0ms.
When set to BPM, the value of each parameter will be set accord-
ing to the value of the "Master BPM" (p. 122) specified for each
patch. This makes it easier to achieve effect sound settings that
match the tempo of the song.
* If, due to the tempo, the time is longer than the range of allowable
settings, it is then synchronized to a period either 1/2 or 1/4 of that
time.
Fbk (Feedback)
Adjusts the feedback amount of the pitch
0–100
shift sound.
Level *1
0–100 Adjusts the volume of the pitch shifter
DirectLev (Direct Level)
0–100 Adjusts the volume of the direct sound.
*1 With Voice set to 2-Mono or 2-Stereo, you can select two sounds.
109