Nortel 1000 Installation And Commissioning Manual page 67

2
3
4
5
6
Copyright © 2003-2007, Nortel Networks
.
main cabinet" (page 68)
expansion cabinet" (page 68)
main cabinet" (page
second expansion cabinet" (page
Connect an NE-A25B cable to each connector associated with a
card slot containing a SILC or UILC circuit card. See
"Cable connectors in main cabinet" (page 68)
connectors in the expansion cabinet" (page 68)
connectors in the expansion cabinet" (page 68)
connectors in the second expansion cabinet" (page 69)
23 "Back of MG 1000S cable connectors" (page 69)
"Back of MG 1000S cable connectors" (page
Tag both ends of each cable with the cabinet or MG 1000S connector
numbers.
Connect the cables to the connectors at the bottom of the cabinet
or at the rear of the MG 1000S.
Replace the retaining bar when you connect all the cables to the
system.
Terminate the 25-pair cables at the cross-connect terminal.
Label the cross-connect terminal for each connector (UILC or SILC).
Figure 24 "SILC port designation label at the cross-connect
terminal" (page 69)
at the cross-connect terminal" (page 70)
designation label at the cross-connect terminal" (page 70)
label used with the BIX cross-connecting system.
Note: Use of the BIX cross-connect system is not mandatory.
The system supports other cross-connect equipment. Refer to
the documentation provided with your cross-connect system for
further information.
Nortel Communication Server 1000
ISDN Basic Rate Interface Installation and Commissioning
NN43001-318 01.02 Standard
Release 5.0 20 June 2007
and Figure 21 "Cable connectors in the
on Figure 20 "Cable connectors in
68), and Figure 22 "Cable connectors in the
69).
and Figure 25 "UILC port designation label
—End—
Installation procedures 67
Figure 20
and Figure 21 "Cable
on Figure 21 "Cable
and Figure 22 "Cable
and Figure
on Figure 23
69).
on Figure 25 "UILC port
show the