Nortel 1000 Installation And Commissioning Manual page 57

5
6
7
8
Copyright © 2003-2007, Nortel Networks
.
secondary reference clock. These reference clock sources are
derived from either BRI spans or DSLs (DSL 0 and/or DSL 1).
Note 2: A clock controller is required in every cabinet or MG
1000S that contains a digital trunk.
Install the SILCs and UILCs. See
and UILCs" (page
Remove the SILCS and UILCs, if previously installed. See
18 "Removing the SILC and UILC" (page
Install the PRI hardware. See
hardware" (page 64).
Note: This step is required for packet data implementation only.
Connect the ISDN BRI terminals or trunks.
a. Connect the ISDN BRI terminals for line applications:
1. Connect system cables to the cross-connect terminal.
See Procedure 20 "Connecting system cables to the
cross-connect terminal" (page
2. Cross-connect the DSLs at the cross-connect terminal.
See Procedure 21 "Cross-connecting the DSLs at the
cross-connect terminal" (page
3. Connect the terminating resistor to the SILC DSL. See
Procedure 22 "Connecting the terminating resistor to the
SILC DSL" (page
4. Connect the ISDN BRI terminals to the DSL. See
23 "Connecting the ISDN BRI terminals to the DSL" (page
76).
5. Initialize a Nortel Networks M5317TDX terminal. See
Procedure 24 "Initializing a Nortel Networks M5317TDX
terminal" (page
b. Connect the ISDN BRI trunks for trunking applications:
1. Connect the system cables to the cross-connect terminal.
See Procedure 25 "Connecting the system cables to the
cross-connect terminal" (page
2. Cross-connect the DSLs at the cross-connect terminal. See
Procedure 26 "Cross-connecting DSLs at the cross-connect
terminal" (page
Nortel Communication Server 1000
ISDN Basic Rate Interface Installation and Commissioning
NN43001-318 01.02 Standard
Release 5.0 20 June 2007
Procedure 17 "Installing the SILCs
61).
Procedure 19 "Installing the PRI
66).
70).
74).
80).
82).
83).
Installation procedures 57
Procedure
64).
Procedure